Flexible Corner Connector

Philips Hue is great, but it only allows for a single, continuous lightstrip run. Litcessory products allow for several! This flexible corner connector, specifically designed for the Philips Hue Lightstrip system, enables you to connect two lightstrips with a sharp angle and is more versatile than a hard 90-degree connector, which requires precise alignment of your two lightstrips. This flexible corner connector is 2 inches/50 mm long and can be folded over to give you a 1 inch/25 mm margin of error when installing your lightstrips.

NOTE: If you want to connect this product directly to the Philips Lightstrip Plus Controller, you MUST use the Litcessory “Controller to 6-Pin Adapter" to do so.

If you want to connect to a cut lightstrip, you must use one of our 6-Pin to Cut-End products. Please see our product line chart below for more info.

This product is great for...

• Joining two light strips with a sharp corner
• Acting as a 2-inch/50 mm extension for breaks between light strips
• Flexing to adapt to installations where installation is difficult

Important things to keep in mind...

• Male ends are removable, converting them to female.
• Supports lightstrip runs up to 33 feet/10 meters (lightstrips and extension cables combined).
• Cable is UL Listed.
• Made for Indoor Dry Locations Only.

Top Uses of a Litcessory Flexible Corner Connector

Frequently Asked Questions:

Will Litcessory products cause my Philips Hue Lightstrip Plus to be dimmer?

• No, Litcessory products do not affect the brightness of the lights, as long as your total lightstrip run length (Philips Hue lightstrip length plus any Litcessory product length) stays within 10 meters/33 feet, your lights will be just as bright!

Philips says their lightstrips are expandable to a maximum of 10 meters/33 feet. If I use an extension cable or ethernet cable, does this affect the 10 meter/33 foot limit?

• We recommend keeping your total lightstrip run under 10 meters/33 feet. This includes the total length of your lightstrips and any Litcessory products and ethernet cables. Some customers have reported success going over this limit, however we have not tested this.

I have a cut Philips Hue lightstrip and I need to add a Litcessory extension cable and connect another cut Philips Hue lightstrip. How do I do this?

• To connect two cut lightstrips together with a Litcessory Extension Cable, you will need our 6-Pin to Cut-End Connectors. This connector has a cut-end connector on one side and a 6-pin connector on the other side.
• Connect the cut-end connector side to the cut lightstrip.
• Plug the extension cable into the 6-pin side of the 6-Pin to Cut-End Connector.
• Connect a second 6-Pin to Cut-End Connector to the other cut lightstrip
• The extension cable now has two 6-pin connectors to plug into between the two cut lightstrips. All Litcessory products with male pin headers are removable, so you can make them male or female as needed for your project.

Do Litcessory extension cables have LED lights on them?

• No, Litcessory products do not have any LED lights.