Self-Programmable Remote Car Key Replacement

An inexpensive replacement for your original remote key fob, the Keyless2Go car key replacement is self-programmable and comes with easy do-it-yourself instructions to help you program your new car key at home. Enjoy keyless entry on a wide variety of vehicles from Nissan and Infiniti. Each fob key has been pre-tested to ensure compatibility and that signals are transmitting properly. Every remote key fob comes complete with batteries and free tech support to help get your new smart key working.

Compatibility:

2003-2008 Infiniti FX35
2003-2008 Infiniti FX45
2002-2004 Infiniti QX4
2004-2015 Nissan Armada
2002-2016 Nissan Frontier
2003-2008 Nissan Murano
2012-2016 Nissan NV1500, NV2500, NV3500
2002-2013 Nissan Pathfinder
2004-2015 Nissan Titan
2007-2012 Nissan Versa
2002-2015 Nissan Xterra
2005-2010 Nissan Quest
2011-2013 Nissan Juke "S"
2008-2013 Nissan Rogue

*Will not work if you have Nissan Intelligent Key (also known as smart key, proximity system, push button ignition)


How to Program your Keyless2Go Key Fob Replacement:

1. Close and lock all doors with the driver’s side power lock switch located on drivers door panel.
2. Insert key into ignition (DON’T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds (this will need to be done at approximately one second intervals). You may need to insert and remove the key up to 10 or 12 times until your hazard lamps flash. PLEASE NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast or too slow the system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push the LOCK button on the keyless remote. Your hazard lamps will flash. PLEASE NOTE: Do not press the button on the remote more than one time or the programming will not be successful.
5. If there are any remaining remotes (including working ones), Unlock then Lock all doors using the switch on drivers door panel. Within 5 seconds of locking and unlocking doors press LOCK button on the next remote. Your hazard lamps will flash. Repeat this step for each remote (including any working remotes).
6. When all remotes have been programmed turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door. Test all remotes.

Note: You must have all remotes on hand when performing this procedure. Any remotes not used during this procedure will become inactive.