Note: The recommended print setup for Overture filaments could be slightly different from other filaments; Pls read the description below, you may also get some practical suggestions through QA/ Top Review from others.
FAQs:
Why can't the filaments stick to the build bed?
1. Check the temperature setting before printing, ABS filaments have higher extrusion temperature;
2. Check if the plate surface has been used for a longtime, it is recommended to replace it with our new one to ensure an strong first layer adhesion ;
3. If the first layer has poor adhesion, it is recommended to re-level the print substrate to reduce the distance between the nozzle and the surface plate;
4. If the effect is not good, it is recommended to try printing the draft before printing.
Specification:
Recommended Extrusion/Nozzle Temp: 245C - 265C (473F~ 509F )
Heated Bed Temp: 80C - 100C (176F~ 212F)/ PVP stick helps
Printing Speed:30~70 mm/s (1,800~4,200mm/ min)
Fan: Low for better surface quality; Off for better strength
Raft
Filaments Diameter and Accuracy: 1.75 mm +/- 0.05
Filaments Net Weight: 2 kg (4.4 lbs)
Packaging Included:
2 × spool of ABS filaments
2 × surfac