Step 1: Do you have the right Clug?
If you haven’t already, you’ll need to check that the Clug you got is the right size for your tire.
As a handy guide, we also put the maximum and minimum sizes for each Clug right on the side of the box. Just hold it up to your tire and check to see that it is within the range.
Note: Clug is a tiny bike rack that works with your floor to store your bike. Clug can't Hang your bike, it doesn't work that way and you might hurt your back trying. We wouldn't want that.
|
Step 2: Location and Alignment
Time to figure out where your Clug is going. Once you’ve found your section of the wall, you can use the alignment guide on the box to get your hole spacing marked precisely.
Holding your bike in the position you want it (you can get a friend to help here), you’ll want to align the position of your Clug with the centre of your wheel, where the tire touches the wall.
|
Step 3: Drills, Holes, and Anchors
You’ll need to drill some holes if you are putting Clug on anything other than wood surface (or a stud in the wall). To drill, just stick your template lightly to the wall and drill right through the guide.
If you drilled holes, insert the anchors from your box into the holes to give you something to screw into.
|
Step 4: Screws, Clip, and Grip
Separate the Clipper from the Gripper and screw the Clipper into the wall.
You’ll be able to make small adjustments before you tighten the screws fully, to make sure that your Clug is level.
Snap the Gripper in to cover the screw heads, and you’re ready to Clug!
|