Directions for Use:
1- For best results, surfaces should be clean and dry.
2- Cut nozzle and apply a continuous 1/16” to ¼” (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange.
3- Let dry for one hour then tighten to torque specifications.
4- Allow 24 hours to fully cure before filling with fluids or returning to service.
5- Replace cap after use.
Note: Not recommended for use on head gaskets or parts in contact with gasoline.