HOW TO INSTALL WHEEL HUB AND BEARING?
1.Guide new module onto CV shaft and into knuckle. (Align carefully or premature failure may result!) Before completing installation, attach ABS connector (if so equipped) and check with key on to ensure vehicle is reading a correct signal from the sensor
2.Torque hub mounting bolts (steering knuckle to module flange) to manufacturer’s specifications, using appropriate torque wrench
3.Reassemble brake rotor and caliper.
4.Torque axle nut to manufacturer’s specifications. Do so while vehicle is raised and hub assembly is unloaded. Replace with new axle nut. Do NOT use an impact wrench.
5.Replace tire/wheel on vehicle. Lower vehicle to ground and torque lug nuts to specification, using a torque wrench
Installation