CYEVA 100ft Rain Barrel Drip Irrigation Kit with Y Shape 2-Way Splitter, 1/4" Blank Distribution Tubing, DIY Water-Saving System for Vegetable Garden Patio Pot Plants Raised Bed
Y Shape 2-Way Splitter: Equipped with a Y-type water separator which can be individually switched, allowing two watering routes be controlled independently without affecting each other
Pressure Requirement: Working water pressure requirement is 25-45 psi. It’s better to use a pump to increase your rain barrel’s pressure than gravity. If your water pressure is above 45 psi, it’s recommended to add a pressure regulator.
Save 70% Water and Time: No longer have to do the time-consuming watering and stand the heat outside, enjoy a summer without hand watering! Reduce water usage up to 70% compared to manually watering
2 Different Drip Emitters: Drippers for irrigating at root zone and nozzles for misting above the plants. Each emitter can be adjusted individually by rotating, meeting the water demand of different plants at one time
TIPS: Put the head of tube into hot water (160~180℉) for 10-15 sec before assembling, helps soften the tube, allow connecting more solidly and avoid leaking or blow off. In order to balance the water pressure, the closer to faucet, emitters should be adjusted to the smaller water flow
Working water pressure requirement for this irrigation system is 25-45 psi
It’s better to use a pump to increase your rain barrel’s pressure than gravity. If your water pressure is above 45 psi, it’s recommended to add a pressure regulator.
Tips:
Please connect the drippers/sprays to the hose as deep as you can so that they will not get blown off.
Soak the end of the tubing in hot water (160-180℉) for 15 seconds helps soften the tube. It will be easier to set up them together. After it cools down the tube will stay tight.
To get the water flow for the far sprayers, please balance the flow rate for all the drippers --- rotate the near drippers to small value, rotate the far drippers to the maximum value.
CYEVA 100ft Rain Barrel Drip Irrigation Kit with Y Shape 2-Way Splitter, 1/4" Blank Distribution Tubing, DIY Water-Saving System for Vegetable Garden Patio Pot Plants Raised Bed
CYEVA 100ft Rain Barrel Drip Irrigation Kit with Y Shape 2-Way Splitter, 1/4" Blank Distribution Tubing, DIY Water-Saving System for Vegetable Garden Patio Pot Plants Raised Bed
Working water pressure requirement for this irrigation system is 25-45 psi
It’s better to use a pump to increase your rain barrel’s pressure than gravity. If your water pressure is above 45 psi, it’s recommended to add a pressure regulator.
Tips:
Please connect the drippers/sprays to the hose as deep as you can so that they will not get blown off.
Soak the end of the tubing in hot water (160-180℉) for 15 seconds helps soften the tube. It will be easier to set up them together. After it cools down the tube will stay tight.
To get the water flow for the far sprayers, please balance the flow rate for all the drippers --- rotate the near drippers to small value, rotate the far drippers to the maximum value.
Liquid,cream or cosmetics items are quantity limited in shopping agent service
Chinese medicine is limited to ship by Chinese exporting goods.
2 Limitation for different shipping methods:
3 Yoybuy Product's Label:
Sensitive Product(SEN)
Product With battery
Cream
Powder
Dangerous Products
4 Volume weight Requested:
volume weight=length*height*Width/5000
one side must be less than 120cm,otherwise there is additional fee;250cm products can not be accept;
Any side must be less than 60cm,otherwise you will be charged the greater one between real weight and volume weight,more than 120cm will be not accepted.