Installation Description
Unplug the existing connector and plug the control box into the two ends of the connector you just unplugged - then run the long ones out to the bags.
Before you zip-tie them in place, check your turn signals to make sure you have the right & left sides correct.
Ran the wires out to just behind the shocks and then up and over into the bags (with the connector for each light inside the bags).
Please use alcohol to rubbing to make sure your bags are clean before sticking the lights on.
Peel a small part of the red stuff off the double-sided tape first. Hold them in place and peel the rest from underneath (while still holding in place). Press firmly to make sure it's stuck tight.