●Tips for LED Light
- 1.Please make sure the sealing ring is undamaged, and properly stay in the groove.
- 2.Please twist the light until it can not be twisted any further, to make it fully waterproof before putting underwater.( Very Important!!! otherwise it will leak)
- 3.Please dry the lights first before replacing batteries. Because the water outside lights may drop into lights and keep inside the battery case, it will damage the components, and defeat the lights.
- 4.For long time use, we recommend to use rechargeable battery to save batteries and money, recommend brand "Energizer" or "Eneloop",don’t use the brand "Tenergy".
- 5.Because some rechargeable batteries are a little big to insert into the battery case, so the contact is not connecting properly, the light will not light up. If the lights don't light up once you insert all 3 batteries, please move the battery to make them connect properly.
- 6.It’s better not use in hot water, because the vapour may go into the light, it will damage the components and lead to stop working.
- 7.If you don’t use for following long time, pleae remove batteries, it will help save power and protect led bulb.
|
●Tips for RF Remote Control
- 1.Please remove the plastic insulating film on the bottom of remote before using it.
- 2.Please long press the button "ON" on the remote for about 2 second to activate all the lights. After turning on, no need to long press, the light will be very sensitive to react what you set.
- 3.For underwater using, please keep the remote within 10FT/3M-16.4FT/5M, because water will largely absorb signal, and weaken the signal to the lights.
- 4.In air, the remote range can reach 164FT/50M and more.
- 5.Low Battery Checking: Press the button "B", if it's no or very weak light, it means low battery, lease replace new batteries.Low power will weaken the sensitivity of remote.
- 6.Out of Power Checking: When the light stays in flashing red light, cannot control by other setting, it means it will be out of power soon, please replace new batteries.
- 7.Check the Remote Battery: When press the remote, you can see the red light on, if cannot see, it mean the remote is out of power, or it doesn't work, please remove the plastic film or replace new batteries.
|
●Tips for Suction Cups
- 1.Suction cup can be used in both air and underwater on flat and smooth surfaces. But not work on rough surface.
- 2.Please clean the surface before attaching, make sure there is not any stuff between the surface and suction cup, especially remember to remove the lubricant like shower cream, moss etc. ( very Important!!!)
- 3.We already enlarged the suction cup to bigger size (30mm) and tighter adsorptivity, it's competent to hold lights under 10-16.4ft/3-5m underwater.
|
●Tips for Remote Range
- 1.LOFTEK remote uses radio frequency (RF) technology, it has stronger penetration, it has further remote range 200ft in air, and 16.4ft underwater, and better remote sensitivity. (IF remote only supports about 2ft.),
- 2.Becaues wall or barrier will disturb the signals transmission, and water will largely absorb signals, so please try to turn off other signal source, and keep closer to the lights.
- 3.In all, RF signal is much better than IR remote control for this submersible light.
|