Hubsan H501A X4 Air Pro GPS RC Drone HD Camera 1080P Wifi FPV Racer 400m Range Wifi Relay Signal Booster （H501A+HT011A)

Camera resolution: 1920 * 1080 30FP Motor: Brushless motor Flight time: about 20 minutes Operation mode: Left hand throttle mode 2 (Mode 1/2 changeable)

• GPS waypoint
• Feel free to draw your destination on the mobile device screen with your fingertips, the drone fly towards your chosen destination.
• Follow Me Mode
• Because there is a built-in GPS system, the drone will automatically face the drone camera to the pilot and follow the pilot.
• Return to Home
• When the RTH switch is pushed up while the GPS switch is ON, the drone enters the RTH mode and the flight control system automatically controls the drone to return to the take off point. (It will not function unless the drone acquires six or more satellites)
• Headless mode
• You can enjoy the operation of the drone with a natural operation feel regardless of the nose direction.
• Fail-safe mode
• If the drone is unable to receive the signal from the transmitter, it enters fail-safe mode. The flight control system will automatically control the drone and return to the home point (take off point) and land automatically.
• Maintain altitude
• It is an altitude maintenance function by atmospheric pressure sensor. Wifi relay built-in transmitter HT011A can fulfill the aircraft steering distance of 800 m!

Increase flight and FPV range to 400 m,RC Quadcopter for Adults Beginners

HT011A transmitter is equipped with both 2.4 Ghz signal and Wifi signal,

When maneuvering the quadcopter with the 2.4 Ghz signal, the quadcopter maneuvering distance can reach 800 m,

When maneuvering the aquadcopter with the Wifi signal, the aircraft maneuvering distance can reach 500 m.

• Drone + HT011A + mobile device binding procedure
• ① Press and hold the power button for 1.5 seconds to turn on the HT011A.
• ② In the WIFI setting of the mobile device, select the WIFI signal of HT011A and bind (connect).
• ③ Start X - Hubsan APP. Enter the "Settings" menu and tap the "Relay" tab. Select "Aircraft and relay connection settings" and enter the connection setting page.
• Body + HT 011 A Transmitter Binding Procedure
• ① Press the transmitter's bind button and power on the transmitter, the 2.4G status LED of HT011A will flash.
• ② Turn on the drone, place the transmitter close to the drone, and when the beep sounds from the transmitter, the binding is complete. 2.4G status LED will change from blinking to steady.