Mikomer Decorative Privacy Window Film Rose, Static Cling Glass Door Film Non-Adhesive Window Tints, Anti-UV/Heat Control/Prevent Bird Strikes for Home Office Decoration, 17.5In. by 78.7In.
(Patterns can't ally)Window film privacy level: ★★★☆☆,semi privacy, provide privacy and allow light in. Elegant iron flower pattern, best choice for glass window door decoration. Applicable for most cases, but not suitable for bathroom.DON'T forget to remove backing protective film before putting on glass.
No glue & static cling: no harmful substances release, easy to position and remove without any residue. Reusable: can be reused if not be damaged or smudged.
Control heat and anti uv window cling: solar control properties to reduce heat, glare and block out 99% harmful uv rays, protect your furniture from ageing.
Item size: 17.5*78.7 inch in roll, easily trimmed to required size with scissors or utility knife.
Easy application: only need some soapy water (clear water) to apply it,only use on clean and smooth glass. (Detail instructions, please see the product description below)
Please Note that This Window Film Only Applies on Smooth Glass Surfaces. Do not Apply to Outside window or Windows with Crack.
Don't forget to remove transparent backing side before putting on glass or it will not cling (Use a tape on a corner of the back side (the smooth side) to quickly remove the backing protective film).
TEMPERATURE ATTENTION! It's more difficult to install the static cling window film in winter than in summer. Please use a hair dryer to soften the film before applying under cold weather (Heat Resistant up to 176℉)
Why choose Mikomer Window Film?
Glue Free Design
Static cling window film, easy to install and remove in minutes with no residue.
No harmful substance release.
Provide Privacy and Allow Light in
Provide semi privacy-keep birds from crashing and pets barking from seeing outside.
No broken blind anymore.
Widely Application
Widely used on office,lounge,bedroom,sliding doors or windows.
Replace traditional curtains with this elegant and beautiful window film.
1.Clean glass (make sure your glass is clean and smooth).
2.Please use a hair dryer to soften the film before applying under cold weather (Very important in cold weather).
3.Cut the film into required size and peel off the transparent backing film.
4.Wet glass (the more water, the better).
5.Past the smooth side to glass.
6.Scraper the film from up to down, left to right. The more water, the easier you can squeeze out bubbles.
7.Cut the excess film (leave a small gap about 1 cm between the film and window to let water flow out).
Questions & Answers
Q1: Why my film does not stay?
A1: Please don't forget to remove the transparent backing film, and then wet the window with soapy water.
Q2: Too hard to remove the backing protective film, is there any tricks?
A2: Take two pieces of tape and place them on opposite sides of the same corner. Make sure you cover the corner completely but leave some tape on each side to grab onto. When you pull the tape apart the film and the backing should separate from each other easily.
Q3: I have removed the back film and wet the widow, why still can not stay?
A3: You may apply the wrong side. The film is divided into two layers, one side is smooth, and the other side is rough. Please tear it off and retry the smooth side to paste again.
Q4: There are a large number of small bubbles.
A4: Too less water. Tear it down, spray a lot of water and paste it again. And then use a card to squeeze out all water and bubbles.
Q5: Why the edge of my window film begins to fell off?
A5:(1) The edge of film is too close to the window. Please leave a small gap (about 2-3 mm) to let the water flow out so that the film can stick well.
(2) Too cold in winter. Please use a hair dryer to soften the film before applying under cold weather (Heat Resistant up to 176℉).
Mikomer Decorative Privacy Window Film Rose, Static Cling Glass Door Film Non-Adhesive Window Tints, Anti-UV/Heat Control/Prevent Bird Strikes for Home Office Decoration, 17.5In. by 78.7In.
Mikomer Decorative Privacy Window Film Rose, Static Cling Glass Door Film Non-Adhesive Window Tints, Anti-UV/Heat Control/Prevent Bird Strikes for Home Office Decoration, 17.5In. by 78.7In.
Please Note that This Window Film Only Applies on Smooth Glass Surfaces. Do not Apply to Outside window or Windows with Crack.
Don't forget to remove transparent backing side before putting on glass or it will not cling (Use a tape on a corner of the back side (the smooth side) to quickly remove the backing protective film).
TEMPERATURE ATTENTION! It's more difficult to install the static cling window film in winter than in summer. Please use a hair dryer to soften the film before applying under cold weather (Heat Resistant up to 176℉)
Why choose Mikomer Window Film?
Glue Free Design
Static cling window film, easy to install and remove in minutes with no residue.
No harmful substance release.
Provide Privacy and Allow Light in
Provide semi privacy-keep birds from crashing and pets barking from seeing outside.
No broken blind anymore.
Widely Application
Widely used on office,lounge,bedroom,sliding doors or windows.
Replace traditional curtains with this elegant and beautiful window film.
1.Clean glass (make sure your glass is clean and smooth).
2.Please use a hair dryer to soften the film before applying under cold weather (Very important in cold weather).
3.Cut the film into required size and peel off the transparent backing film.
4.Wet glass (the more water, the better).
5.Past the smooth side to glass.
6.Scraper the film from up to down, left to right. The more water, the easier you can squeeze out bubbles.
7.Cut the excess film (leave a small gap about 1 cm between the film and window to let water flow out).
Questions & Answers
Q1: Why my film does not stay?
A1: Please don't forget to remove the transparent backing film, and then wet the window with soapy water.
Q2: Too hard to remove the backing protective film, is there any tricks?
A2: Take two pieces of tape and place them on opposite sides of the same corner. Make sure you cover the corner completely but leave some tape on each side to grab onto. When you pull the tape apart the film and the backing should separate from each other easily.
Q3: I have removed the back film and wet the widow, why still can not stay?
A3: You may apply the wrong side. The film is divided into two layers, one side is smooth, and the other side is rough. Please tear it off and retry the smooth side to paste again.
Q4: There are a large number of small bubbles.
A4: Too less water. Tear it down, spray a lot of water and paste it again. And then use a card to squeeze out all water and bubbles.
Q5: Why the edge of my window film begins to fell off?
A5:(1) The edge of film is too close to the window. Please leave a small gap (about 2-3 mm) to let the water flow out so that the film can stick well.
(2) Too cold in winter. Please use a hair dryer to soften the film before applying under cold weather (Heat Resistant up to 176℉).
Liquid,cream or cosmetics items are quantity limited in shopping agent service
Chinese medicine is limited to ship by Chinese exporting goods.
2 Limitation for different shipping methods:
3 Yoybuy Product's Label:
Sensitive Product(SEN)
Product With battery
Cream
Powder
Dangerous Products
4 Volume weight Requested:
volume weight=length*height*Width/5000
one side must be less than 120cm,otherwise there is additional fee;250cm products can not be accept;
Any side must be less than 60cm,otherwise you will be charged the greater one between real weight and volume weight,more than 120cm will be not accepted.