Before paste the skins, please noted two issues:
- -- After the 3M upper and bottom skin paste finished, do not re-lift, otherwise, the skins will be damaged.
- -- We design the product off 0.5~1 mm gap to edge,please take care of its placeholder, this is avoid curl during usage.
- 100% clean up the laptop body
- Peel off and cut half of the backing paper(or middle 1/3), align its edges/corners/logo holes to the laptop body
- If the alignment process is not good, you can slowly take it away, and then remove and re-alignment
- If the edges, corners and LOGO cut openings have been aligned perfect,paste it to the computer
- After it, then please tear off the remaining half of the backing paper carefully
- Paste the other half of the skin at the same time
- Slowly use push card or JRC cloth gentle squeeze out the bubbles.
Screen Protector Instruction:
- Position the screen protector on top of the screen making sure it match perfectly
- 100% Clean the screen with carefully with JRC cloth and alcohol
- Peel off the half of backing film (sticker-1),we suggest you start from left to right, same time make sure the left and top line and camera hole is align ok. when these is full ok, slowly peel off the half backing film.
- During the process, if you found there is dust inside of it, please find 3 in 1 sticker to absorb the dust carefully.
- After you apply entire screen protector use the card or cloth to wipe out the bubble
- If bubbles out, peel off the upper film(sticker-2),finish