TIPS:
1. It is best to use an alkaline battery 1.5v
(other batteries can also be used, but there will be no water in 3 days, not necessarily the battery is empty, it may be that the battery used cannot be better by the timer system Identification, so it is recommended to use 1.5v alkaline batteries)
2. There will be a self-test mode after the battery is installed,
the middle light will flash quickly, and then two clicks and the light will go out, indicating that the system self-test is completed (the first sound is louder, it is turned on by default after a click Da second sound is in normal working state, the second sound will be very quiet)
3. Turn on the water after installing the faucet, you can adjust it to the normal on or off state by on / off, and then start to set the working time
4. Each time the hand turns the turntable, the light will light up
5. When the battery power is sufficient, the light will not light up or blink. When the battery is low, the light will flash every 7-8 seconds.
6. When replacing the battery, remove the old battery and replace it with a new battery, then dial the dial arbitrarily to let the electricity in the capacitor discharge
7. Because it is a solenoid valve, it must work at a pressure of 1.5-5 Pa
8. The timer is normally turned off when no battery is installed. If the battery is used and the battery is dead, there will be 2 situations:
(1) When the timer is in the watering state, the timer is not powered: then the timer will not be turned off, and the watering will continue;
(2) If the set watering time has not yet reached and the timer has no power, the timer will not turn on watering even if the watering time is up.