This amplifier gives you the power and versatility you need to create a professional sound system. Its wide frequency response makes it suitable for amplifying any type of audio including music or vocals. It can be used in meeting halls, restaurants, schools, stores, and at home --the perfect solution for paging systems anywhere. Get the power you need with 2 x 40 Watt to handle all your audio needs.
When set to 'mixing' the signals from AUX1, AUX2, CD, & MIC will exist at the same time and works great for creating a karaoke event. Your music will play from your selected audio source and you will be able to sing through a connected microphone. (Microphone not included)
When set to 'pager' the signal from AUX1, AUX2, & CD will be attenuated by -10dB and the signal from MIC will override to page (Auto Talkover) and makes for an exceptional paging system.
Lets you easily connect speaker wires directly to the amplifier. The speaker impedance can be ranged from four to eight Ohms for the general stereo output. The total speaker impedance must be at least four Ohm per channel at stereo mode.
This amplifier has selectable input voltage from 110 V/60 Hz (the standard in USA and Canada) to 220 V/50 Hz (for European operation). Please make sure the switch is in the proper position before operating.
Accepts headphones with 1/4-inch plugs.
Accepts microphones with 1/4-inch plugs.
Lets you connect the amplifier to a tape deck for recording.
Use the control center panel located on the face of the unit to make adjustments to microphone volume, master volume, balance, bass, and treble
The amplifier uses a fuse for protection against surges and short circuit. If the amplifier suddenly turns off and will not turn on, check the fuse, and replace it if necessary. (Replacement fuse to use: 1.5-amp, 250-volt, fast-acting .2 x .8 inches fuse -not included)
Drag the image here, or Click to upload Tips: Only jpg, jpeg, png, webp
Scan the QR code and use your phone to take a direct photo search.
×