Balancing your Stabilizer by following 3 Steps below: 1) Adjust the upper and lower balance
Take out the stabilizer and install your camera onto the quick release plate, and then please follow up following steps to adjust the balance, it may takes a few minutes to make it in balance:
- Lift the bottom base of stabilizer and make the stabilizer in parallel to the ground and then let the bottom base fall down freely (make sure your another hand grab the handle tightly or it will fall down to the ground and may damage your camera);
- If it falls down very fast (less than 2~3 seconds), then you will need to reduce the weight plat quantities from the bottom base and test it again by following step 1 above;
- If it falls down too slow (longer than 3 seconds), then you will need to extend the stabilizer a little bit longer and then test it again by following step 1 above;
Above steps may need take a few minutes and the judgement is the bottom base fall down timing at 2~3 seconds