How to Use:
- Always On (flashlight) Mode: Press-and-hold the switch for 2 seconds to turn the light ON; then press-and-hold the switch for 2 seconds to turn the light OFF.
- Motion & Light Sensor Mode: Under Always ON Mode, Short-press the switch once, and you will see a GREEN indicator flash for 1 second; it is now in Motion & Light Sensor Mode. Motion Sensor and Light Sensor are all able, so the light only turns on automatically when detecting human’s movement in dark enough condition.
- ONLY Motion Sensor Mode: Under Motion & Light Sensor Mode, Short press the switch again, and you will see a RED indicator flash for 1 second; it is now in ONLY Motion Sensor Mode. Only the Motion Sensor is able, light bar will turn on automatically when detecting human’s movement, not only in dark condition, but also in daytime.
- Another short-press of the switch changes between the two sensor modes; you will see either a GREEN indicator or a RED indicator flash, telling you which mode it is in.
|
Widely Application:
- Offer super bright lighting in any place where need extra light, make it much easier to see and less mistakes.
- Such as closet, wardrobe, bedroom, cabinet, workshop, cupboard, bookcase, shed, garage, hallway, kitchen under cabinet, over the sink, stairway, laundry, drawers, steps etc.
Charge Description:
- Charging: Blue light
- Fully Charged: Red Light
- Charge Time: 4-6 hours (When charging, indicator light is Blue. Fully charged,indicator light will change to Red)
|
Specification
- LED Lumen: 240lm
- Detecting Angle: 120 degree
- Detecting Distance : up to 3m (about 10ft)
- LED Life Time : more than 80000h
- Battery: 2200mAh lithium battery
- Operating Voltage: 4.2V
- Wattage: 3W
- Size: 44x 2.2x 2.2cm (17.3x 0.8x 0.8in)
|
Kindly Note
- When installing the closet lighting, please put the sensor ball in position just face to the direction you walk toward to, so that it can fully detect the motion.
- Under Motion & Light Sensor Mode, please don't put 2 motion sensor closet light too close and don't use them at the same time, due to they will influence light's motion sensitivity reciprocally.
What You Get
- 1 x LOFTER Motion Sensor Closet Light
- 1 x Plastic Bracket
- 2 x 3M Adhesive
- 4 x Screws
- 1 x USB Cable
- 1 x User Manual
|