Instructions For Use
1. Prepare Surface: Apply only to clean smooth surface. To clean, use soap and water. Rinse and dry thoroughly. Products may not adhere to fabric, rough or pebbly surfaces or surfaces under 55°F (13°C). Porous surfaces should be sealed completely with enamel, shellac, urethane or similar product.
2. Measure and Cut: It is recommended to allow at least 3/8” (1cm) overlap on all edges for possible shrinkage.
3. Peel off Backing: When covering large areas, peel backing small sections at a time to make it easier to apply. Peel off backing evenly.
4. Apply: Beginning at the center, press out towards edge using squeegee, straight edge tool or cloth. Covering may be lifted and repositioned during application to eliminate bubbles or wrinkles. Avoid pulling or stretching. A hot gun can be a helpful tool when applying Con-Tact Brand 'Surfaces' over edges. Once liner is applied to the surface, wave the hot gun tool a couple inches from the liner where you will be folding over edges. This should only take a few seconds. Once Con-Tact 'Surfaces' liner has softened slightly, press firmly to edging for stronger adherence and easier application.