Afeax OEM Compatible with iPhone Face Front Camera Flex Cable with Sensor Proximity Light and Microphone Flex Cable Replacement for iPhone 7 Plus 5.5inch
Following is the basic instruction step to replace the iphone 7 plus front camera replacement.
Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
Step 1
1.Remove the two 3.4 mm pentalobe screws at the bottom edge of the iPhone.
Step 2
2.Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.Insert the flat end of a spudger into the gap.
Step 3
3.Slide an opening pick underneath the display along the top edge of the phone to loosen the last of the adhesive.
Step 4
4.Pull the display assembly slightly away from the top edge of the phone to disengage the clips holding it to the rear case.
5.Remove the following four tri-point Y000 screws securing the lower display cable bracket to the logic board.
Step 6
6.Remove the lower display cable bracket.
Step 7
7.Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
Step 8
8.Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector.
Afeax OEM Compatible with iPhone Face Front Camera Flex Cable with Sensor Proximity Light and Microphone Flex Cable Replacement for iPhone 7 Plus 5.5inch
Afeax OEM Compatible with iPhone Face Front Camera Flex Cable with Sensor Proximity Light and Microphone Flex Cable Replacement for iPhone 7 Plus 5.5inch
Following is the basic instruction step to replace the iphone 7 plus front camera replacement.
Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
Step 1
1.Remove the two 3.4 mm pentalobe screws at the bottom edge of the iPhone.
Step 2
2.Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.Insert the flat end of a spudger into the gap.
Step 3
3.Slide an opening pick underneath the display along the top edge of the phone to loosen the last of the adhesive.
Step 4
4.Pull the display assembly slightly away from the top edge of the phone to disengage the clips holding it to the rear case.
5.Remove the following four tri-point Y000 screws securing the lower display cable bracket to the logic board.
Step 6
6.Remove the lower display cable bracket.
Step 7
7.Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
Step 8
8.Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector.
Liquid,cream or cosmetics items are quantity limited in shopping agent service
Chinese medicine is limited to ship by Chinese exporting goods.
2 Limitation for different shipping methods:
3 Yoybuy Product's Label:
Sensitive Product(SEN)
Product With battery
Cream
Powder
Dangerous Products
4 Volume weight Requested:
volume weight=length*height*Width/5000
one side must be less than 120cm,otherwise there is additional fee;250cm products can not be accept;
Any side must be less than 60cm,otherwise you will be charged the greater one between real weight and volume weight,more than 120cm will be not accepted.